• Vibration isolation in all directions.
  • Noise attenuation.
  • Easy installation because of one-piece design.
  • Low-cost installation.
  • Long service life.
  • Consistent performance because of permanently bonded design.
  • Shock protection in all directions provided by cushioned snubbing, no metal-to-metal bottoming.
  • Standard sizes available from stock.
  • Space-saving size.
  • Captive installation after overload failure when recommended bolt, washer and nut are used.
  • Accommodate English and Metric bolts.
Unit of Measure

Specifications

Load for Maximum Static Load Rating1 N/A 450 lbs2000 N

Deflection for Maximum Static Load Rating

N/A 0.04 in1.02 mm

Dimension A (± 0.03)

N/A 1.75 in44.5 mm

Dimension B (± 0.01)

N/A 0.515 in13.1 mm

Dimension C (± 0.015)

N/A 1.24 in31.5 mm

Dimension D

N/A 1.25 in31.8 mm

Dimension E (± 0.015)

N/A 1.00 in25.4 mm

Dimension F (± 0.02)

N/A 0.41 in10.4 mm

Size Imperial (Recommended Bolt Information)

N/A 1/2

Size Metric (Recommended Bolt Information)

N/A M12

Grade or Class SAE J429 (Recommended Bolt Information)

N/A 2

Grade or Class SAE J1199 (Recommended Bolt Information)

N/A 5.8
Nominal Dynamic - Static Spring Rate Ratio2 N/A 1.22

Tolerances for Dimensions

N/A .xx = ± 0.03 in. (± 0.762 mm)
.xxx = ± 0.015 in. (± 0.381 mm)

Washer

N/A , Tail Washer
, Washer

Required Mating Directions

Dimension H (± 0.03)

N/A 0.38 in9.7 mm

Minimum Diameter ID

N/A 2.00 in50.8 mm

Minimum Diameter KD

N/A 1.50 in38.1 mm

Dimension SD (± 0.03)

N/A 1.12 in28.4 mm

Dimension T (± 0.03)

N/A 0.38 in9.7 mm

Dimension R (± 0.015)

N/A 0.06 in1.5 mm

General Description

N/A Center Bonded Mounts provide flexible suspension systems for mobile, transport-mounted or portable equipment. Typical applications include engines, cabs, fuel tanks, pumps, air conditioning units, compressors and industrial machinery.

Application Engineering Assistance

N/A Frequently, vibration isolation problems require a system engineering analysis. Lord has the computer capability, as well as specialized programs, for analyzing engine/ transmission combinations. The output from this analysis is a mounting proposal which optimizes performance over the complete range of operating speeds. This service is available to you upon request.

Note

N/A Mounts and washers only supplied by Lord.
In applications where the mounts will be immersed in oil, parts made in oil-resistant elastomer are available. Contact Lord Corporation for additional information.

  • 1 These ratings are for general industrial applications. For on-highway use 80% of loads shown. For off-highway use 70% of loads shown.
  • 2 This column of figures can be used to calculate dynamic spring rate for natural frequency based on static values.

    (KDYN= KST x DYN/STATIC Ratio)